User Manual

12 13
TESTINGINSTALLING & REPLACING BATTERY BOX
Installing The Battery Box
1. Remove the extension cable from the
back of the bowl (The cable is attached
inside the back of the toilet. Tug it
gently to let it free.)
2. Plug the cable into the battery box.
Then, secure the water-proof nuts.
3. Place the battery box in its proper
position shown on the right. The
batteries and cables are divided into
positive and negative poles. Do not
forcefully connect them. Doing so
may damage the product. If you
have any questions, please call
Bio Bidet at 847.458.2334.
Replacing The Battery Box
1. Loosen the battery box screws
and remove the cover. Remove
the battery and safely discard it.
2. Load the new CR-P2 battery and
re-secure the screws.
3. Place the battery box back
into its place.
The battery should be kept out of
children’s reach. Please ensure that the
battery’s polarity is correctly matched. If
they are incorrect it may lead to chemical
leaks or explosions. The battery box is
water proof so please make sure all the
screws are tightly secured to ensure that
the box is perfectly sealed.
Testing the Water Flow
1. Open the water supply valve.
2. Check each connection for leaks
3. If leaks occur, turn off the water supply valve and
re-connect the leaking components.
Connecting Power
1. Plug in the power cord.
2. Check to see if the power light is on.
If not, push the reset button.
3. Once the power light is on, the toilet will run its
initial diagnostics: lights will turn on, cleaning
nozzle will extend, the motor will begin to run and
water will run through the system. Once the light is
off, the self-diagnostic is complete.
Testing the Product
1. Are all the functions working properly? Please
test all of the following functions: Posterior Wash,
Front Wash (including water pressure and nozzle
position adjustment), Heated Dryer, Water and
Seat Temperature Adjustment, Nozzle Cleaning,
Deodorization, and Remote Control.
2. To check the posterior wash, place a hand on
the sensor point (shown in the illustration), press
Posterior on the Side Control Panel or the wireless
remote. Use your hand to block the nozzle spray.
seat sensor