Table of Contents PRODUCT INFORMATION Features Parts List PRODUCT INSTALLATION Pre Installation Installing the Bidet Sprayer PRODUCT OPERATION How to use the A1 MAINTENANCE
Product Information High quality ceramic valve Dual Sprayer 6’ Comfortable handle body Easy DULY installation Ambient temperature bidet wash Adjustable water pressure 58” Metal spiral hose No electricity or batteries required One year warranty
Handheld Bidet Spray Holster XZ Expanding nut (use to fix the spray holster on wall) T-Valve Shutoff (Be sure Flat Washer is inside end of T-Valve) Supply Hose Screw (use to fix the spray holster on wall)
PRODUCT INSTALLATION CAUTION :Do not over tighten any connections.Over tightening connections can cause damage to the parts and cause leaking. When installing this unit,be sure that the water supply valve is fully turned off. Failure to do so can result in flooding and water damage. 1.Shut off water supply to toilet. Flush toilet to drain all water inside the tank.
PRODUCT INSTALLATION (cont.) 2.Disconnect the supply line from the toilet fill valve.Attach 7/8” T-Valve Shutoff to the threaded fill valve on your toilet. Be sure the 7/8” Flat Washer is in the T-Valve before installing.Position the T-Valve so that the shutoff handle is facing the front of the toilet. 3.Reattach your existing toilet supply line to the bottom of the T-Valve. Be sure all connections are secure, and no leaking or water is present. 4.
5.Attach the Handheld Bidet to the other end of the supply hose. As a precaution, Turn OFF slide the level on the handheld bidet sprayer to is away from the sprayer head. 6.Mounting Spray Holster: Option: Toilet Mount: Carefully remove toilet lid and place holder in desired location. Option: Wall Mount: Using a Phillips screwdriver, remove the plastic toilet clip. Find desired location on wall near toilet and use screw (included) to attach the Holster to wall. Use expanding nut if attaching to dry wall 7.
PRODUCT OPERATION Operation 1. Open the T-Valve to allow water to flow to the Handheld Bidet sprayer. 2. Direct the Handheld Bidet to the appropriate area and slide the lever to the “on” position. 3. When finished, slide the lever to the “off” position and close the T-Valve. NOTE: THE T-VALVE MUST BE SHUT OFF AFTER EACH USE. Failure to turn off after each use may cause flooding and water damage.
Warranty Your Bio Bidet is warranted against defects in materials or workmanship for one (1) year from the Date of original purchase.
Technical Support /Customer Service Bio Bidet 7900 S Route 31 Crystal Lake IL 60014 U.S TOLL FREE :877.339.5214 www.
