Specifications

63
6 Wall Lines - typically for countertops
Scribe – the wall lines will be drawn through each point
on the wall.
Straight – the wall lines will be drawn in a single straight
line from corner to corner.
Wall Offset
Full Offset – the entire wall line is offset a constant
distance, as defined by the wall offset, either to the
inside or outside.
Corner Offset – Available only with straight wall lines.
Each end of the line can have its own offset value, as
defined b the open and closed corner values.
Integrator BackPlot Settings Point Definitions Layer Definitions
1
Point definitions are the points sets used to define walls
and edges.
• Walls are drawn as polylines.
• Edges are line segments.
Multiple points are used for polylines.
Edges require an even number of points. (Only 2 points
per line segment).
2
To edit point sets, select the set to be edited, and then
select the Edit button.
3 Use the Add and Remove buttons to change the set.
Once complete, select the OK Button.
Point numbers used to define the perimeter (wall and
cabinet edge) should be in the Selected Points list to
make them active. Any points regularly used for interior
references, such as sink or stove top, and any used for
high bars, as well as the X and Y markers should be in
the Available Points list, making them inactive.