Specifications

61
Integrator BackPlot Settings Point Definitions Layer Definitions
1
All of the system configurations concerning the output of
the systems can be changed using settings.
There are several systems configurations that can be
created. The following will describe what each function
can accomplish in general terms.
2 Settings Group
Outside radius – defines radius of external corners
created by two finished edges.
Inside Radius – defines radius of internal corners
created by two finished edges.
Overhang - defines overhand on finished edges.
Wall height – used when defining open walls for room
design.
Wall Offset – backsplashes, wall cladding, room design,
etc. Create wall lines for installation clearances and for
radius of wall markers.
Open corners –This is the offset value for the exposed
end of a wall line. When used, this is usually set to a
very small value or to zero to minimize the gap between
the countertop and the wall.
Closed corners – Offset value for the corner created by
two walls meeting. This is set to a value that will create a
gap small enough to be covered by the backsplash.
Splash height – Defines the height of the backsplash
Splash Oversize – Defines any oversize so that the
splash can be cut to exact length at the job site.
Note Size – text height in the output CAD drawing
Label Size – text height in the output CAD drawing
Note: If using metric –
all values must be converted to mm