Specifications

60
3 Default Z Point – allows you to define Z height where
the 2D dxf profile will be plotted
Z – Height can be used as a correction for the
thickness of the edge marker used to determine cabinet
height.
Markers are .375 inches, if they are on a cabinet edge.
A negative value of -.375 is applied. The number is
rounded to -.40
4
Distance between points defines the
resolution of the lines. A higher resolution
results in a higher definition line.
NOTE: Too much definition will keep a large project
from being completely imported.
5 Control Point prefix is used when more than one or
multiple projects are imported. If you do not use this
prefix, the current project displayed will be overwritten.
6 Select the Process button to export the dxf into
ETemplate.
Note: Do not press Process more than once.