Specifications

55
Process Center:
Overview
The Process Center has two functions:
1) It exports the processed ETemplate results to a specified design file format
2) It can project the wire frame line design from the complete .dxf file back into the photos from
which it was exported.
The export function differs from the Export Model process in ETemplate in that you can preset
defaults in the Process Center such as layers, line drawing, offsets, overhangs, corner radius
and others. These defaults can be set and will remain set from project to project, unlike Export
Model which requires that you set parameters fresh with each project. At the same time, the
Process Center allows easy access to change any defaults to suit individual aspects of any
project.
The Integrator, Settings, Points Definitions and Layer Definitions tabs are all involved with the
export process.
The Integrator tab sets the file type of the exported file and includes three settings that
will draw lines connecting the points in your exported file as per you set instructions. It will
also export just points or points with layers.
The Settings tab lets you set and change particular aspects of each file you export.
The Points Definitions tab informs the drawing function which points are involved in the
perimeter drawing process by category.
The Layer Definitions tab allows you to set layers for points and leave them set unless
you need to change them for and individual project.
The BackPlot tab allows you to project the complete lines from your design file back into
the project photos in order to make final checks of your template prior to fabrication.
(All of the tab functions will be discussed in detail on the pages that follow.)