Specifications

33
ETEMPLATE PHOTO JOBSITE SETUP CHECK LIST
JOBSITE HARDWARE PLACEMENT
Intelli -- Marks
(Coded Targets)
• Plac e t a r gets ev ery 1 2- 18” -- at leas t 2 p er ed ge
• Plac e o n top o f cabine ts/coun te r tops
• Plac e o n walls /c abine t faces
• Mak e sur e at l e as t 15 c oded tar gets will be i n each p hoto
Intelli -- Marks
Stickers
• Plac e a l ong w a ll(s) as desire d and o n c abi n et fac es f or r em odel i ng
Intelli -- Marks
Edge Markers
• Plac e f l at or st a ndin g vertica ll y o n en ds or f ac es of c abine ts f or a l l
nec ess a r y prof i les (i .e .: edge pr ofile , s ink c e nter, etc .)
• Plac e m ark e r s t o be u sed as X 1 / X 2 axis a nd Y1 / Y2 ax is (m us t be
on sam e flat p l an e)
Intelli -- Marks
Scales
• Lie flat or on edge or angle, on cabinets or countertop
• Place 1 scale EVERY 8-10 FT
(scale 40-50% of overall project linear length)
• Scales are Necessary for ACCURATE measurement
Additional
Information
• Use a small white board, notepads, or sticky notes placed
in photos to note all additional styles, reveals, or other
miscellaneous, necessary measurement information
Note: Use enough of above hardware items to insure each photo will contain a minimum
of 15 markers spread out across each complete image to insure that each photo will
satisfy the Rule of Overlap and facilitate automatic processing in the ETemplate Photo
software. The more common or overlapping points among photos and the better spread
of the markers across each complete image, the better chance for the automatic
processing wizard to complete the project.
See Process Center for more information on Job-site set-up