Specifications

25
Troubleshooting with Point Audit Selected or Point Audit All
Select All photos & Open, then visually verify references are correct on each yellow highlighted
set of ID markers, Tag if not, for later correction or click NEXT in Audit box to continue
verification, until all point ID sets have been checked.
Use TAG while using the REFERENCING | POINT AUDIT ALL or SELECTED
tool, above, in order to note what point ID set needs troubleshooting.
Once an audit has been completed, and the dialog box is closed, a user can
right click on a “T” tag in a photo and select
OPEN PHOTOS SHOWING SELECTED
Or
If all photos are opened and tiled to the workspace, select
EXPAND SELECTION TO ALL WINDOWS
Close the Point Table
Selected point(s) will be highlighted red in the photos. The necessary action
can be done and the tag can be cleared by clicking
EDIT | CLEAR SELECTED or ALL TAG(s)
Use Measure Mode to check measurements between 2 markers on photos or
on the 3D Viewer point set, by selecting 1 marker, press & hold Shift, and
select the second marker for measurement between.