Specifications
24
Click Project > Scale & Rotate (ignore Scale when using Constraints)
Click Rotate tab to define a flat plane needed for template
Define a flat plane:
Click one (1) point for X1, hold Shift, click another point for X2
Verify 2 similar markers are used on a straight edge, from left to right
Click Define
Click one (1) point for Y1, hold Shift, click another point for Y2
Verify 2 similar markers are used on a straight edge, from front to back
Click Define, Process and Save
Check Point Table
Largest Residual Pixel Size should be under .80
Tightness (in) should be .04 or less
Save project file intermittently and before continuing to the next step
***R
OTATE MUST BE COMPLETED BEFORE
F
ILE
/E
XPORT
M
ODEL
***
Set the property of a specific group of points to a new layer name for easier access
during the CAD template creation:
•
select a group of points in photo(s) while holding down Shift key
•
Right mouse click and select properties of selected
•
Select material/layer tab
1.
If a layer name has been added, use pull down to select layer name, click Apply and
then OK
2.
If no layer name is defined, click Mark/Layer and then Add. Type in desired name, select
desired layer, click apply and OK