Specifications

23
ADD [File | Add/Remove Photos] only 1 photo at a time, or if adding 3-4 at a time
remember all photos marked "use and adjust" must satisfy the 6/1 RULE of
Overlap to enable processing to produce a 3D model and it's "value of goodness"
Mark, Save
Reference, making sure each added photo has at least [6/1 RULE of Overlap]
6+ marks in common with one (1) other photo, and has 1+ mark in
common with two (2) other photos for referencing to enable processing
Process, , Save
Add scale if there is only one scale in the project. Open a photo with a scale in it.
Click Project > Scale & Rotate > click Scale tab
Click one (1) end point of a scale, hold Shift, click the other end point, verify the
appropriate Scale Distance, click Define, OK, and Save.
A scale cannot be used as both a constraint and a scale
Use 1 scale or if using more than one scale, use constraints, NO scale
Add Constraints instead of scale
1. Click Constraint Definition Mode click one (1) point on the first scale, hold
Shift, click the other end point
2. Click Add New Constraint and in Constrain Properties type is 2 points
to be a given distance apart, default Scale Value is 46.000, click OK
3. Process and SAVE
-- Repeat Constraint Definition steps 1- 3 for all scales in the project --
IF USING ETEMPLATE PHOTO VERSION 2.2, WE NO
LONGER USE THE SCALE FUNCTION. ALL SCALING IS
DONE WITH THE CONSTRAINT DEFINITION MODE TOOL.
(OR BY SETTING DISTANCE CONSTRAINTS IN A
SETTINGS
FILE USED IN THE PROJECT WIZARD)