Specifications

22
Manual Tools of ETemplate Photo V2
Click Sub-pixel Target Mode
 Mouse over marker, press alt to zoom in on Intelli-Mark, center cursor target
over a mark and click + drag box around mark, release mouse button,
release alt key; repeat for all marks
N OTE : If a mark is partially covered/blocked it should not be marked and used
because it may affect the Tightness (in.) value indicating a possible inaccuracy.
Click Reference
 Select one (1) photo as Source (left side – Reference photo) and the other as
Destination (right side - Photo)
 For referencing, select/highlight point(s) in Source photo using one of the
following three methods:
1
Single select by left mouse clicking a marker
2
Select window/box: by left mouse clicking + dragging a window around
multiple markers
(may select multiple windows/boxes, by pressing Shift to add to a selection)
3
Right click for pop-up menu in source photo and click Select All
4
Add to a selection by holding the SHIFT key down while continuing to
single select, or drag multiple windows
N OTE : Click Shift + F to maximize multiple photos to their workspace screens.
 Bring mouse into Destination photo and (match) click appropriate point one
at a time – following yellow highlighted numbers in the source photo
N OTE : If highlighted point in Source photo is not in Destination photo –
press Esc to skip to the next selected point.
TIP : REFERENCING POINTS CORRECTLY THE FIRST TIME SAVES TIME
Click Process to orient photos
 Total processing error should be under .25 for good projects.
N OTE : If Point Table Quality Assessments are within their limits, the Total
processing error may be greater than .25 in some 4-5 photo projects.