Operating instructions
Connecting the headset
The he ad set is con nec ted to the se pa ra te he ad set so cket on the sys tem te le pho ne as shown on pa ge 5 in Fig. 2. Next
pla ce the he ad set ca ble
3
in the ca ble gui de
4
and clamp it se cu re ly un der the ca ble clips
5
.
If the he ad set cord do es not fit in the ca ble gui de, stick the ad he si ve ca ble clip supp lied on to the ba se of the sys tem te -
le pho ne
7
. Then lay the headset cord under this clip.
Configuring the headset
Headset connectorelmeg CS410 elmeg IP-S400
1
Mi cro pho ne +
2
Re cei ver (Ground)
3
Re cei ver
4
Mi cro pho ne (Ground)
Headset connector elmeg CS410-U, elmeg CS410
1
DSHG re cei ver
2
Earth (Ground)
3
Mi cro pho ne +
4
Re cei ver (Ground)
5
Re cei ver (3.3V swit cha ble over re sis tan ce)
6
Mi cro pho ne (Ground)
7
V+ (3.3V)
8
DSHG trans mit ter
Ot her set tings for the use of the he ad set
You can use eit her the re cei ver or the he ad set to ma ke a call. When using a he ad set, the fol lo wing set tings are re qui red
or available:
· In the con fi gu ra ti on of the sys tem te le pho ne, set up a functi on key for ope ra ting the he ad set (he -
ad set key, see page 36).
· The con nec ted he ad set can be used au to ma ti cal ly for cer tain ope ra tions on the sys tem te le pho ne
(see page ).
· If spe ci al sup port is sa ved in the sys tem te le pho ne for your he ad set, en ter the cor re spon ding type
of he ad set (see page 48).
e.g. the LED in the mi cro pho ne of the »Fi re fly F142 N« from Plan tro nics is swit ched through the
system telephone.
· If you want to use the he ad set to au to ma ti cal ly re cei ve calls, set the time to au to ma tic pi ckup (see
page ). In the con fi gu ra ti on of the sys tem te le pho ne, set up a functi on key for ac ti va ting or de ac ti -
va ting automatic call pickup.
· Using the he ad set the ans we ring ma chi ne can be que ried if au to ma tic he ad set ope ra ti on is set up.
Connecting the system telephone (connector and receiver cord) Un pa cking and po si tio ning
7
4
3
2
1
Fig: 4
8
7
6
5
4
3
2
1
Fig: 5