Operating instructions

Connecting the cord

S-con nec tor

Con nect the S-cord

as shown in Fig. 2 (so cket S0). Plea se no te that the lon ger ISDN plug must be in ser ted in the

ISDN so cket and the shor ter ISDN plug must be in ser ted in the ISDN so cket on the sys tem te le pho ne. Next pla ce the

S-cord in the ca ble gui de

and clamp it se cu re ly un der the ca ble clips

Up0-connectorelmeg CS410-U:

Con nect the S-cord

as shown in Fig. 3 (so cket Up0). Plea se no te that the lon ger ISDN plug must be in ser ted in the

ISDN so cket and the shor ter ISDN plug must be in ser ted in the ISDN so cket on the sys tem te le pho ne. Next pla ce the

S-cord ca ble in the ca ble gui de

and clamp it se cu re ly un der the ca ble clips

, This elmeg CS410-U may no lon ger be con nec ted to an ISDN con nec tor via an S0 so cket (e.g. in ter nal

S-con nec tor of the elmeg PABX).

, You can con nect a furt her ISDN ter mi nal with S-in ter fa ce (e.g. an ISDN card or anot her sys tem te le -

pho ne) to the S0 so cket on the sys tem te le pho ne. The po wer supp ly at this con nec tor for anot her ISDN

terminal is 1 Watt.

Connecting and setting the headset (not included)

You can con nect a he ad set to the sys tem te le pho ne. Plea se ask your dea ler or con sult the In ter net to find out which

he ad sets are compatible.

elmeg CS410-U. elmeg IP-S400

The he ad set con nec tor on the sys tem te le pho ne is an 8-pin so cket. He ad sets with DSHG in ter fa ce (e.g. cord less DECT

he ad sets) can be con nec ted di rect ly to the sys tem te le pho ne wit hout any ac ces so ries. For stan dard he ad sets (4-pin

cord, e.g. U10PS) use the adapter cable supplied.

Un pa cking and po si tio ning Connecting the system telephone (connector and receiver cord)

Fig: 3