User's Guide

This document is subject to change without prior notification.
Binsfeld Engineering Inc. | 231-334-4383 www.binsfeld.com 869610-9_A2 Pg. 32
Command Description
byte0
cmd
code
byte1
byte2
byte3
chksum
Receiver RF communications
byte1 – Operational mode
Block = 0, Stream = 1,
Standby = 2
byte2 – Block and Standby
Mode byte2 is same as
System RF communications
(both RX and TX) below (cmd
code 0x9a)
value baud
samples/sec
0 (0x71) 250K 50
1 (0x74) 250K 500
(default)
2 (0x77) 250K 5000
If already in standby, sending
the standby command with the
same byte2 value starts the
wake process. Sending the
standby command with a new
byte2 value updates the
baud/sps that will be used but
does not start the wake
process.
If the standby wake process is
active, sending the standby
command with any byte2 value
cancels the active process.
byte2 - Stream Mode: ignored
0x6a
chksum