User's Guide

This document is subject to change without prior notification.

Binsfeld Engineering Inc. | 231-334-4383 www.binsfeld.com 869610-9_A2 Pg. 13

2.2.5.3 Standby Mode

This is the TX20K low power, sleep mode. It is used to conserve battery

power between test sessions. No torque or status data is transmitted

while in Standby Mode. The TX20K wakes from this mode every 15

seconds to see if the RX20K is sending Wake commands. If not, the

TX20K goes back to sleep. If the TX20K receives a Wake command

from the RX20K, it will wake and operate at same Block Mode

baud/sample rate as when it was put to sleep. Resetting power of the

TX20K will take it out of Standby Mode and back into Block Mode

operation.

2.2.6 Signal Accuracy

Below are the TX20K’s maximum signal errors at 25

˚C along with the

temperature coefficients for each range setting.

Table 5, TX20K signal accuracy

Input

Range

mV/V

Zero Error

% Full Scale

Scale Error

% Reading

Zero TC

ppm/°C

Scale TC

ppm/°C

0.2

0.02

0.25

0.5

0.02

0.25

0.15

0.20

0.15

0.20

0.15

0.20

0.15

0.20

0.15

0.20