Technical data

BD / ED / FD 01/2006 page 34/49
We recommend entering a maintenance agreement. Please consult the BINDER service department.
BINDER telephone hotline: [phone]
BINDER fax hotline: [phone] 93555
BINDER e-mail hotline: [e-mail]
BINDER service hotline USA: [phone] (toll-free in the USA)
BINDER Asia Pacific: + 603 6204 2855
BINDER Internet homepage http://www.binder-world.com
BINDER address BINDER GmbH, post office box 102, D-78502 Tuttlingen
International customers, please contact your local BINDER distributor.
10.2 Cleaning and decontamination
DANGER
Electrical hazard.
Danger of life.
∅ Do NOT spill water or cleaning agents over the inner and outer surfaces.
¾ Put off-circuit the unit before cleaning. Pull the power plug.
¾ Completely dry the appliance before switching it on again.
Cleaning
Disconnect the chamber from the mains before cleaning. Pull the power plug!
Wipe the surfaces with a moistened towel. In addition, you can use the following cleaning agents:
Exterior surfaces
inner chamber
racks
door gaskets
Standard commercial cleaning detergents free from acid or Halogenide.
Alcoholic solutions.
We recommend using the neutral cleaning agent Art. No. 1002-0016.
Instrument panel Standard commercial cleaning detergents free from acid or Halogenide.
We recommend using the neutral cleaning agent Art. No. 1002-0016.
For surface protection, perform cleaning as fast as possible.
After cleaning completely remove cleaning agents from the surfaces with a moistened towel.
Decontamination
Disconnect the chamber from the mains prior to decontamination. Pull the power plug.
You can use the following disinfectants:
Inner chamber Standard commercial surface disinfectants free from acid or Halogenide.
Alcoholic solutions.
We recommend using disinfectant Art. No. 1002-0022.
In case of impurity of the interior with biological or chemical hazardous goods, there are three possible
procedures depending on the type of contamination and of the charging material.
(1) The heating/drying ovens ED and FD can be hot air sterilized at 190°C for at least 30 minutes. All
inflammable goods must be removed from the interior before.
(2) Spray the inner chamber with an appropriate disinfectant.
Before start-up, the unit must be absolute dry and ventilated, because explosive gases might form
during the decontamination process.