Installation & Assembly

NOTICE TO
CUSTOMERS
THE GAP IN THIS GATE IS NOT A FAULT.
THE GAP WILL DISAPPEAR WHEN THE
GATE IS CORRECTLY INSTALLED.
PLEASE INSTALL GATE ACCORDING TO
MANUFACTURER’S INSTRUCTIONS.
IMPORTANT NOTICE
to Customers
The gap in this gate is NOT a fault.
The gap will disappear when the
gate is correctly installed.
Refer to enclosed instructions for
correct installation procedures.
F - Gate Notic
e
WARNING: This package contains small parts and
sharp points in an unassembled state. Keep out of
reach of children. Adult assembly required.
PARTS LIST
1 Gate Panel
2 Upper Locking Set
3 Release Switch with Latch
4 Right Upper Corner
5 Tension Knobs
6 Bolts with Rubber Pads
7 Mounting Cups
8 Gate Frame
9 Lower Locking Set
1 2 3 4 5
7
9
8
2
1A
1. Measure the width of the opening of where you intend to install the gate.
Ensure the surface that you are mounting the gate is structurally sound such as solid timber,
brick or masonry.
For plaster/gyprock surface, locate the timber beam or stud behind and mount in this location
(mounting on plaster/gyprock alone is not strong enough and not safe). Do not mount to glass.
For openings over 82cm (32in) select the appropriate Gate Extension(s).
INSTALLATION
71 - 82cm (28.3 - 32in)
6