Installation guide

WR1500N 150Mbps Wireless N Router
 Shares data and Internet access for users, supporting Dynamic IP/Static IP/PPPoE Internet
access.
 Supports Virtual Server, Special Application and DMZ host.
 Supports UPnP, Dynamic DNS, Static Routing.
 Provides Automatic-connection and Scheduled Connection on certain time to the Internet.
 Connects Internet on demand and disconnects from the Internet when idle for PPPoE.
 Built-in NAT and DHCP server supporting static IP address distributing.
 Supports Stateful Packet Inspection.
 Supports VPN Passthrough.
 Supports Parental Control and Access Control.
 Provides 64/128/152-bit WEP encryption security and wireless LAN ACL (Access Control
List).
 Supports Flow Statistics.
 Supports firmware upgrade and Web management.
1.4 Panel Layout
1.4.1 The Front Panel
Figure 1-1 Front Panel sketch
The Router’s LEDs and the WPS/Reset Button are located on the front panel (View from left to
right).
Name Status Indication
Off Power is off.
PWR
On Power is on.
On The Router is initializing.
Flashing The Router is working properly.
SYS
Off The Router has a system error.
Off The Wireless function is disabled.
WLAN
Flashing The Wireless function is enabled.
Off There is no device linked to the corresponding port.
On
There is a device linked to the corresponding port but
there is no activity.
WAN,
1,2,3,4 (LAN)
Flashing There is an active device linked to the corresponding port.
Slow Flash
A wireless device is connecting to the network by WPS
function. This process will last for about 2 minutes.
On
A wireless device has been successfully added to the
network by WPS function. The LED will keep on for about
5 minutes.
WPS
Quick Flash
A wireless device failed to be added to the network by
WPS function.
Table 1-1 The LEDs Description
- 3 -