Installation guide

WR1500N 150Mbps Wireless N Router
There are two submenus under the IP &MAC Binding menu (shown in Figure 4-41): Binding
Setting and ARP List. Click any of them, and you will be able to scan or configure the
corresponding function. The detailed explanations for each submenu are provided below.
4.12.1 Binding Settings
This page displays the IP & MAC Binding Setting table; you can operate it in accord with your
desire as shown in Figure 4-42.
Figure 4-42 Binding Settings
 MAC Address - The MAC address of the controlled computer in the LAN.
 IP Address - The assigned IP address of the controlled computer in the LAN.
 Bind - Check this option to enable ARP binding for a specific device.
 Modify - To modify or delete an existing entry.
When you want to add or modify an IP & MAC Binding entry, you can click the Add New… button
or Modify button, and then you will go to the next page. This page is used for adding or modifying
an IP & MAC Binding entry, shown in Figure 4-43.
Figure 4-43 IP & MAC Binding Settings
To add IP & MAC Binding entries, follow the steps below.
1. Click the Add New... button as shown in Figure 4-42.
2.
Enter the MAC Address and IP Address.
3. Select the Bind checkbox.
4. Click the Save button to save it.
To modify or delete an existing entry, follow the steps below.
1. Find the desired entry in the table.
2. Click Modify or Delete as desired on the Modify column.
To find an existing entry, follow the steps below.
1. Click the Find button as shown in Figure 4-42.
2. Enter the MAC Address or IP Address.
3. Click the Find button in the page as shown in Figure 4-44.
- 46 -