Installation guide

WR1500N 150Mbps Wireless N Router
 WEP Index - This option should be chosen if the key type is WEP(ASCII) or WEP(HEX).It
indicates the index of the WEP key.
 Auth Type - This option should be chosen if the key type is WEP(ASCII) or WEP(HEX).It
indicates the authorization type of the Root AP.
 Password - If the AP your Router is going to connect needs password, you need to fill the
password in this blank.
4.6.2 Wireless Security
Choose menu “Wireless → Wireless Security”, you can configure the security settings of your
wireless network.
There are five wireless security modes supported by the Router: WEP (Wired Equivalent Privacy),
WPA (Wi-Fi Protected Access), WPA2 (Wi-Fi Protected Access 2), WPA-PSK (Pre-Shared Key),
WPA2-PSK (Pre-Shared Key).
Figure 4-15 Wireless Security
 Disable Security - If you do not want to use wireless security, check this radio button. But it’s
strongly recommended to choose one of the following modes to enable security.
 WEP - It is based on the IEEE 802.11 standard. If you check this radio button, the page will
appear as shown in Figure 4-16.
- 29 -