Operation Manual

60
.
9.7.3.2 Using the Menu
1. Press <MENU/OK> and <UP/DOWN> to select ANS. MACHINE.
2. Press <MENU/OK> and <UP/DOWN> to select TAM SETTINGS.
3. Press <MENU/OK> and <UP/DOWN> to select OGM SETTINGS.
4. Press <MENU/OK> and <UP/DOWN> to select ANS & REC or
ANSWER ONLY
5. Press <MENU/OK> and <UP/DOWN> to select DEFAULT.
6.
Press <MENU/OK> to show PIN?, and then enter the system PIN
7. Press <MENU/OK> to replace the current OGM with the default OGM.
The display will then return to the previous menu.
.
(default 0000).
9.8 Switch Between OGMs
By default, the answer machine is set in ANS & REC mode which allows
callers to leave a message. This mode can be changed to ANSWER ONLY
which does not allow callers to leave a message. In that case, your callers
will be prompted to call back later.
When the answering machine is switched ON, you can select ANS & REC
1.
Press <MENU/OK> and <UP/DOWN> to select ANS. MACHINE.
2.
Press <MENU/OK> and <UP/DOWN> to select TAM SETTINGS.
or ANSWER ONLY.
Using the Menu
Press <MENU/OK> to show ANSWER MODE.
Press <MENU/OK> and <UP/DOWN> to select ANS & REC or
3.
4.
Press <MENU/OK> to confirm.
5.
ANSWER ONLY.
9.9
9.9.1 Play the TAM messages
If you have new messages, the base display will show e.g. 01/02 MSGS,
New messages are played first, and then are saved as old messages, until
they are deleted. Old messages are played again after all new messages
are played completely.
TAM Messages
which means you have 1 new message out of a total of 2 messages.