Operation Manual

56
12
1212
12 ADVANCED SETTINGS
ADVANCED SETTINGSADVANCED SETTINGS
ADVANCED SETTINGS ON YOUR CORDLESS HAN
ON YOUR CORDLESS HANON YOUR CORDLESS HAN
ON YOUR CORDLESS HANDSET
DSETDSET
DSET
12.1
12.112.1
12.1 Cordless
Cordless Cordless
Cordless Handset
HandsetHandset
Handset Registration
RegistrationRegistration
Registration
I
II
IM
MM
MPO
POPO
POR
RR
RT
TT
TA
AA
AN
NN
NT
TT
T:
::
: When you purchase your phone system, all handsets are
already registered to your base, so you do not need to register them.
Handset registration is only necessary when you buy extra cordless
handsets or if a cordless handset has become faulty.
You can register up to four handsets to one base station, with each
handset’s number (1 to 4) shown on its display.
Note:
Note:Note:
Note: Each handset can only be registered to one base.
You need to enter the Master PIN before you can register or unregister
handsets. The default Master PIN is 0000
00000000
0000.
12.2
12.212.2
12.2 Register A
Register ARegister A
Register Addition
dditionddition
dditional
alal
al Cordless
CordlessCordless
Cordless H
HH
Handsets
andsetsandsets
andsets
1. In standby mode, press and hold the
key under the corded base
unit for approximately 5 seconds.
•
S on the corded base will flash in Red for up to 1 minute,
and the base will beep, while it is in registration mode.
2. On the cordless handset, press M .
3. Press
+ \-to ADVANCED SET
ADVANCED SETADVANCED SET
ADVANCED SET and then press M to select.
4. Press + \-to REGISTRATION
REGISTRATIONREGISTRATION
REGISTRATION and then press M to select.
• If no action is taken on the handset within 10 seconds, the
registration
procedure will be aborted. If this happens, repeat
from step 1.
5. Enter the Master PIN and then press M to confirm.
Note:
Note:Note:
Note: The default Master PIN is 0000
00000000
0000.
• WAITING
WAITINGWAITING
WAITING
flashes on the screen.
• A confirmation tone is played to indicate successful registration,
and the handset will return to standby mode, with its handset
number displayed.
• If no base is found with the entered PIN, error tones are played
to indicate failed registration and the handset returns to
standby mode. You will need to repeat from step 1 above.