User guide

Customising your base unit

General points You can customise the settings of your e820 base unit,

using a menu which is shown on the handset’s display.

Please note that:

■

If you don’t press any button for about 25 seconds,

the handset will time out and the display will return

to standby mode.

■

When you confirm any setting you have made, you’ll

hear a confirmation tone. If you make a mistake,

you’ll hear a warning tone.

■

At the end of each set of steps, you can return the

handset to standby mode by either:

—

replacing the handset on the base unit

—

pressing and holding the HANG UP/C button

Emergency

numbers

These two numbers can be dialled even when call

barring is set (see page 40).

1 Press the PROG button then 2 2 3 1

2 Key in the first emergency number

3 Press the PHONE/OK button to confirm

4 Press 2 3 2

5 Key in the second emergency number

6 Press the PHONE/OK button to confirm

E:\Binatone2004\e820\e820_UK_03.vp

15 November 2004 11:48:21

Color profile: Generic CMYK printer profile

Composite Default screen