User guide

Customising your handset

General points You can customise the settings of your e820 handset,

using a menu which is shown on the handset’s display.

Please note that:

■

If you don’t press any button for about 25 seconds,

the handset will time out and the display will return

to standby mode.

■

When you confirm any setting you have made, you’ll

hear a confirmation tone. If you make a mistake,

you’ll hear a warning tone.

■

At the end of each set of steps, you can return the

handset to standby mode by either:

—

replacing the handset on the base unit

—

pressing and holding the HANG UP/C button

Auto-answer When a call comes in, you need to press any button to

answer it. Or you can set auto-answer — so, if the

handset is in place on the base unit, you simply lift it to

answer the call, without pressing any button.

1 Press the PROG button then 1 5

2 Use the  or  button to set:

0 for auto-answer off

1 for auto-answer on

3 Press the PHONE/OK button to confirm

E:\Binatone2004\e820\e820_UK_03.vp

15 November 2004 11:48:21

Color profile: Generic CMYK printer profile

Composite Default screen