User guide
3
3.1 Searching broadcasting services 29
2.
Set the Search Mode option to Advanced... and press the
OK button.
3.
Choose your desired transponder at the Frequency op-
tion or enter it with the numeric buttons.
4.
Enter the symbol rate of your desired transponder to the
Symbol Rate option with the numeric buttons.
5.
Set the Polarization option to the polarization of your
desired transponder.
6.
Set the Modulation option to the modulation type of your
desired transponder. If your desired transponder has
high definition broadcasts, you should set this option to
DVB-S2 QPSK or DVB-S2 8PSK. Then the FEC option
and the Pilot option will become enabled. You should
also set these options correctly.
7.
Specify the packet identifiers of your desired service at
the PID option with the numeric buttons. A packet iden-
tifier is used to verify audio and video streams.
8.
If you set all options correctly, press the
MENU
button to
save the settings.
Searching every service of SMATV system
To search every service of a SMATV system, if the digital re-
ceiver is connected to it, perform the following steps:
1.
Choose your desired satellite at the Satellite Name op-
tion.
2.
Set the Search Mode option to SMATV... and press the
OK button.
3.
Choose your desired transponder at the Frequency op-
tion or enter it with the numeric buttons.
4.
Enter the symbol rate of your desired transponder to the
Symbol Rate option with the numeric buttons.