manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don’t change the page numbering.
Keep the language integrity.
Fax [phone]
grid removed before using the appliance. The manufacturer declines all responsibility in case
this is not safe working practices will be respected.
• Before connecting the appliance, check that the voltage values shown on the data plate (220-
240V~ 50Hz) correspond to those of the electricity supply network and that the electric plug
is grounded. In the event of incompatibility between the electric outlet and the plug of the
appliance, have the outlet replaced with another more suitable type by professionally
qualified personnel, who will make sure that the section of the wires of the outlet is
appropriate for the absorbed power of the heater. In general, the use of adapters or extension
cords is not recommended; if their use is indispensable, they must conform to existing safety
standards and their current capacity (amperes) must not be less that the maximum of the
heater.
• The power socket must be easy to reach so the plug can be removed quickly in case of
emergency.
• Do not place the fan on a shelf and/or near sinks or other container of liquids (minimum
distance of 2 meters) to avoid the risk of it falling in.
• Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could obstruct
the air intake grille; make sure that the front is free of unstable materials (dust, etc.).
• Make sure that the electric cord is not touching rough, hot or moving surfaces and not
twisted or wrapped around the appliance.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the
appliance could upset).
• Do not place the appliance near an open flame, cooking or other heating appliance.
• Do not use the appliance with a timer or a programmer or with a system that can switch on
the appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is
covered or positioned incorrectly.
• In the event of a breakdown or poor operation, turn the fan heater off and ask for
professionally qualified help.
ASSEMBLY
Attention: the fan can be used only when completely and correctly assembled, that is complete
with its base and protection grid. If in doubt, have the appliance checked or assembled by a
qualified professional person. For assembly, refer to figure.
Attention: always unplug the appliance before you assemble.
1. Front grill/protective
screen
2. Fan
3. Fan fixing screw
4. Rear grill fixing screws
5. Rear grill
6. Motor shaft
7. Oscillation button
8. Housing
9. Clutch screw (tilt up/down)
10. Switch
11. Cord
12. Screw with nut
7/24
Assembly page 7/20