Specifications


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don’t change the page numbering.
Keep the language integrity.
14 / 40
Assembly page 14/16
Fax [phone]
Use
The fan is operated and goes into stand-by mode via the remote control.
Install the remote control holder to the wall (see figure), place the seat on the remote control to
the wall, drill 2 holes (before drilling holes is good to measure the distance between the slots
first and see if hoses (water and gas, etc. ..) or electrical wires are embedded in the wall, insert
the screw anchors into the holes, place the remote control holder and tighten the screws, place
the remote control.
Before using the remote control, insert n. 2 AAA batteries 1.5 V following the polarity
indicated in each seat (not included).
The buttons operate the following functions (see figure):
Fan in stand-by
Low: Minimum speed
Med: Medium speed
Hi: Maximum speed
ON: light on
OFF: light off
To completely turn off the unit, press "0" (OFF) switch pole of the power supply.