Specifications


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don’t change the page numbering.
Keep the language integrity.
12 / 40
Assembly page 12/16
Fax [phone]
11. Make sure the wires are correctly housed and insert the upper cap into its support plate so
that the holes are aligned: then lock with the screws provided (Fig. 7)
12. Assemble the blades to the motor, placing them the correct way up (be careful with the
side of the blade), and tighten with the screws and washers provided (Fig. 8). Make sure
that all screws are tightened both for safety purposes, but also to prevent the fan from
swinging excessively during operation.
13. Connect the light cable with that on the ceiling: plug and socket must fully engage and
ensure the click tab connection (Fig. 9)
14. Make sure that the wires are tangle-free and placed in the correct way, place and attach
the lamp cover onto the motor body and secure with the screws. (Fig. 10):
a. engage the bulb (not included) corresponding to the specifications given on the
nameplate and / or on the data plate next to the lamp socket, the type VST10 (1xMax 40W,
attacco G9); VSC10 (1xMax 60W, attacco E27).
b. attach the glass lampshade which has a bayonet connection: attach it and turn it to lock
it properly. It is recommended to handle the lampshade with care and, once finished,
check the attachment.