Specifications


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don’t change the page numbering.
Keep the language integrity.
11 / 40
Assembly page 11/16
Fax [phone]
1. Attach the mounting plate to the ceiling: drill the holes, taking care not to damage any
piping inside the wall (first check if there are water or gas pipes etc. .. or electrical wires
embedded in the wall); use expansion dowels and screws with washers to attach the plate.
Make sure it is firmly attached, then apply a weight to the plate 4 times higher than that of
the fan and check that the plate remains perfectly fixed to the base.
2. Insert the support rod through the top cap and insert the electrical cables through the hollow
shaft. The wires are inserted from bottom to top.
3. Insert the lower end of the rod into the motor support pin, so that the holes are coaxial and
insert locking pin.
4. Place the washer on the pin and secure the pin using the cotter pin which must be fully
inserted and then bent so as to prevent both the pin and cotter pin from slipping off.
5. Fix the motor support further to the rod by tightening the safety screw
6. Temporarily hang the fan on the hook on the support plate Make the electrical connections
as explained in the "Electrical Connection" section and then proceed as follows.
7. Remove the fan from the hook on the support plate hold it up so as not to tear / damage
the electrical connections. Check that the wires are free and housed in the correct way and
position the top cap near the support plate. Tighten the screw properly.
8. Hang the fan from the plate, then insert the rod through the gap in the plate, place the semi-
sphere in the centre hole so that the tab is inserted into the groove.
9. Insert the remote control receiver in its seat on the plate (see Fig. 3, Fig.13 and Fig.14),
place the top cap close to the support plate and place the sensor in the side hole on the cap
so that the tip protrudes from the hole (loosen the metal bracket beforehand - see Fig.4):
make sure the sensor is attached to the bracket and tighten the screw. It is possible to place
the sensor outside of the cap, as shown by Fig. 14, Fig.15 and Fig.18.
10. Make sure wires are securely placed between the bracket and cap and connect the
following:
a) fan wires to the remote control receiver: plugs and sockets must engage perfectly (the
colour coding of the labels facilitates the operation) and ensure the connection of the click
tab (Fig. 5).
b) yellow / green wires of the rod with the terminal, plug and socket engaged properly so as
to ensure the click tab connection.
c) power line wires to the terminal block in the following way:
-Yellow/Green wire: Grounding, corresponding to the symbol
-Brown wire “LIVE”: L (phase)
- Blue wire “NEUTRAL”: N (neutral)
(see Fig.6 and Fig.17).