manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don’t change the page numbering.
Keep the language integrity.
10 / 20
Assembly page 10/16
Fax [phone]
Fig.1 Fig.2 Fig.3
• If fixed in a bathroom shall state that the heater is
to be installed so that switches and other controls cannot be touched by a person in the bath or shower.
• Warning: don’t use wet hand touch the working machine and don’t cover the wind outlet and inlet.
• Before each use, verify that the heater is in good condition and that the electrical cord is not damaged:
in the case of doubt, ask for professionally qualified help.
• Make sure that the cable is correctly positioned and that it is not in contact with hot parts or sharp
edges, nor wrapped around the device or twisted.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
Use
Attention: the fan can be used only when completely and correctly assembled, that is complete with its
base.
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the power
cord is damaged, it must be replaced by the manufacturer or a competent qualified electrician or a person
with similar qualifications, in order to avoid any risk.
The fan's functions can be controlled either with the keypad located on the control panel or with the
remote control. The remote control must be pointed at the control panel; for the first use take off the tab
transparent plastic of the batteri’s side (type AAA).
Insert the plug in the socket.
Ventilation:
1) To turn the fan on, press the “ON/SPEED” key on the remote control or the control panel.
2) To select the desired speed in normal mode “NOR”, repeatedly press the “ON-SPEED” key: on the
control panel shows the selected speed (Low=minimum, Med=medium, Hi=maximum) and “NOR”.
Horizontal oscillation (right-left): this is controlled by the “OSCIL” key on the remote control or the
pushbutton panel (14). To eliminate this motion, press the “OSCIL” key again.
Vertical inclination (high-low): it is regulated by gripping the motor body and orienting it in the
direction desired; throught the screw (10) to lock the body in the desired position.
Timer: this function allows setting the operating time and the fan will automatically stop at the end.
• To set the operating time, repeatedly press the “TIMER” key on the remote control or the control panel:
every time the key is pressed, the time set is changed and the indicator light on the control panel lights
corresponding to the time selected (0.5 hour, 1 hour, 2 hours, 4 hours, ecc….): the maximum time is
7,5 hours. To eliminate this motion, press the “0-OFF” key again.