manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don’t change the page numbering.
Keep the language integrity.
6 / 12
Assembly page 6/12
Fax [phone]
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
• Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could obstruct the air
intake grille; make sure that the front is free of unstable materials (dust, etc.).
• Make sure that the electric cord is not touching rough, hot or moving surfaces and not twisted or
wrapped around the appliance.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the appliance
could upset).
• Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly.
• In the event of a breakdown or poor operation, turn the fan heater off and ask for professionally
qualified help.
USE INSTRUCTIONS
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the power
cord is damaged, it must be replaced by the manufacturer or a competent qualified electrician or a person
with similar qualifications, in order to avoid any risk.
1. Speed Knob
2. Timer Knob
3. Oscillation switch
4. Body
• Plug it in.
• The appliance has a timer for automatic switching off at the end of the time set; to set the time turn
the timer knob (2) clockwise to the position corresponding to the desired operating time (0-120
min.); in order to operate the appliance in a continuous manner, and to therefore exclude use of the
timer, turn the knob anticlockwise to the “ON” position.
• Ventilation: set the desired speed using the knob (1), by turning it to one of these positions:
0 = Off 1 = Speed minimum
2 = Speed medium 3 = Speed maximum
To switch off the appliance, turn the selector knob to the “0” position or turn the timer knob to the
“OFF” position, and then remove the plug from the socket.
Diffuser rotation: this obtained by pressing the knob for the purpose (3).
When not in use for long periods, the plug must always be removed from the socket.
CLEANING AND MAINTENANCE
Attention: before normal cleaning, remove the plug from the socket.
• Clean the body with soft, slightly damp, cloth; do not use abrasive or corrosive products.
• Do not immerse any part of the fan in water or other liquid: if this should happen, do not put your hand
in the liquid, but first remove the plug from the socket. Carefully dry the appliance and make sure that
all the electrical parts are dry: in the case of doubt, ask for professionally qualified help.
• It is essential that the motor's air holes be kept from dust and lint.
• Periodically check the electric cord for damage; its replacement requires a special tool: contact an
authorized service center, also for any repairs.