manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t
change the page numbering. Keep the language
integrity.
Fax [phone]
4. Position the tank correctly on the base, making sure that the two arrows (on the base of the tank
in the back) line up.
5. Insert the plug into the socket.
6. Turn the knob (3) clockwise to the desired humidity value and the green indicator will light; the
humidity will be higher, the more the knob is turned towards the maximum position (
), after a
few seconds to start exit steam.
7. When the tank is empty, the appliance automatically turns off and the red, water-tank-empty
indicator light turns on.
8. To refill the tank, repeat steps 1 through 4.
9. To turn off the appliance, turn the selector knob counter-clockwise to “0-OFF” and remove the
plug from the electric outlet.
10. After each use, empty any water residue in the tray (8) inside the base and dry it with a slightly
damp cloth.
If the device is not to be used for a long time, remove the plug from the electric outlet and make
sure the tank and inside of the base are perfectly dry.
Descaling
To extend the life of the humidifier and its accessories (ceramic filter, etc.), remove the lime scale
after about 500 litres (or more frequently if the water is very hard).
Ceramic filter:
1. Remove the tank plug and unscrew the lock ring (10) from the filter (9) by turning it counter-
clockwise.
2. Soak the filter in a container filled with white vinegar (8 percent), acetic acid or descaling liquid
for 10 minutes.
3. Carefully rinse the filter under a jet of water and make sure it is perfectly dry before screwing it
in.
Water tank:
a) Add 10 to 15 drops of white vinegar (8 percent), acetic acid or descaling liquid to the inside of
the tank for 5 minutes.
b) Carefully rinse the inside with water and then make sure it is perfectly dry.
Base tray:
1. Clean the inside of the tray with a soft cloth dipped in a mixture of water and vinegar and then
rinse with a soft cloth dipped in plain water. Avoid the use of abrasive products that could
damage the surface finish; do not use scouring pads or abrasive products. Do not wash it under
running water, submerge it in water, or place it in a dishwasher. Before use, check that it is
perfectly dry.
10/24
Assembly page 10/24