manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t
change the page numbering. Keep the language
integrity.
8 / 16
Assembly page 8/16
Fax [phone]
DESCRIPTION OF THE APPLIANCE
Frontal part:
1a. Lower candle switch
1b. Upper candle switch
2. Protection grill
3. Quarz heater
Inferior part:
4. Anti-upsetting system
OPERATION
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the
power cord is damaged, it must be replaced by the manufacturer or a competent qualified electrician
or a person with similar qualifications, in order to avoid any risk.
ATTENTION: The heater must not be used if the plugs are damaged glass.
The appliance is equipped n.2 switch that control the operation regardless of the resistance.
1) Insert the plug into the socket.
2) To turn on the stove and check the power, press the switch, these modes:
1a. pos. 0 = off pos.I= on ⇔ (400W)
1b. pos. 0 = off pos.I= on ⇔ (400W)
3) To switch the appliance off, turn the selector to the “0” off position and remove the plug from
the power socket.
Never leave the appliance connected to the socket if it is not in use, especially for long periods.
CLEANING AND MAINTENANCE
Attention: before cleaning the appliance, switch off, unplug and wait for before it has
completely cooled down.
• Protect the parabola from dust to keep save its reflecting characteristic.
• To clean the body use a soft damp cloth; do not use abrasive products.
• The protection grill and the smocking net are very delicate; to clean them only use your
vacuum cleaner, paying attention not to damage them.
• When the stove is not in use it is necessary to cover and put it in a dry place. We advise to
use the original packing to preserve it from dust and humidity.
• The cable and quarz heater must be substituted with a special tool: please contact a
competent qualified electrician.