manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t
change the page numbering. Keep the language
integrity.
7 / 16
Assembly page 7/16
Fax [phone]
• If the electric cord is damaged, it has to be replaced by the supplier or an authorized service center
or a professionally qualified, to avoid any risks.
INSTALLATION
• After removing the packing materials, check the integrity of the appliance; if you are unsure, do not
use it and ask for qualified professional help. The packing materials (plastic bags, polystyrene
foam, nails, etc.) must be kept out the reach of children because they are potential sources of
danger; but dispose of them in accordance with current law.
• Before connecting the appliance, check that the voltage shown on the data plate matches that of
your electricity (230V~ 50Hz) and that the electric plug is grounded. In the event of incompatibility
between the electric outlet and the plug of the appliance, have the outlet replaced with another
more suitable type by professionally qualified personnel, who will make sure that the section of the
wires of the outlet is appropriate for the absorbed power of the appliance. In general, the use of
adapters or extension cords is not recommended; if their use is indispensable, they must conform to
existing safety standards and their current capacity (amperes) must not be less that the maximum of
the appliance.
• Position the appliance far from other sources of heat, inflammable materials (curtains, carpets,
etc.), inflammable gases or explosive materials (spray cans) and from materials that can deform on
exposure to heat. Make sure that there is 100 cm of free space in front of the appliance and 50 cm
on the sides. Do not use the heater in places where it could be subject to shocks in the immediate
vicinity of a bathtub, shower or swimming pool to avoid drops of water falling on the heater or the
heater falling in the water: If the appliance should accidentally get wet or be submerged in water,
remove the plug from the supply socket immediately and dry the unit carefully. Check that no
liquid has gone inside and if in doubt, contact professionally qualified personnel.
Warning: this symbol indicates the anti-tipping switch. If any buttons have been pressed, the
appliance will start to function immediately.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the
appliance could upset). Make sure the safety system get in touch with the floor, otherwise the
appliance doesn’t work.
• Make sure that the cable is correctly positioned, that it is not touching hot elements or sharp edges,
is not wound around the utensil, is not twisted up on itself or in the way to prevent the utensil from
being pulled over. Check that you cannot trip over to prevent accidental falls or harm to persons.
• The appliance must not be positioned immediately under a socket.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
• Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly.
• WARNING: this heater is not equipped with a device to control the room temperature. Do not use
this heater in small rooms when they are occupied by persons not capable of leaving the room on
their own, unless constant supervision is provided.
• All repairs should be made by a competent qualified electrician. In any case you should return the
appliance to this service.
This symbol show:
ATTENTION
do not cover the appliance when it is
operating to avoid the risk of fires.