manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t
change the page numbering. Keep the language
integrity.
Fax [phone]
• Ensure that the fan works correctly: if this is not the case, switch off the appliance and have it
checked by professionally qualified personnel.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
• Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly.
• In the case of a breakdown or fault, switch off the appliance and have it checked by a
professionally qualified technician; repairs made by unqualified persons can be dangerous and
render void the warranty.
• All repairs should be made by a competent qualified electrician. Any faulty appliances should be
returned to this service.
Portable installation
In order to use the appliance the two feet supplied must be fitted to the same by operating as follows:
- Always unplug the appliance before you assemble.
- Put the appliance down horizontally on a flat, smooth surface.
- Position the feet by inserting the hook into the slot on the side and make it run until the lower
hooks block
- Secure their blocking using the screws supplied.
Wall installation
1) With wall installation, the wall to which the appliance is secured must be made of masonry and/or
of heat-resistant material (not wood, or synthetic material which can easily overheat); also, follow
these indications for the installation:
2) The appliance must be positioned so that the bottom side is away from the floor min. 90mm÷
100mm max from the floor.
3) The upper grill is perfectly horizontal.
4) At a distance of at least 20 cm from the corners of walls.
5) At a distance of at least 100 cm from flammable materials (curtains, fabrics, etc.).
6) Not beneath socket outlets
- Fit two hooks (fig.2) to the wall at a distance of 51,2 cm apart and at least (see fig.2)
- Insert the metal bracket into the lower grill half way up the rear panel (vedi fig.3)
- Hang the convector heater on the wall by inserting the hooks into the slots provided in the rear
panel (see fig.4)
- Mark the exact positioning of the hole at the centre of the metal bracket on the wall; make a hole
in the wall and use a screw to secure the appliance to the wall in this way.
9/28
Assembly page 9/28