manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t
change the page numbering. Keep the language
integrity.
Fax [phone]
exposure to heat. Make sure that there is 100 cm of free space in front of the appliance and 50 cm
on the sides.
• Do not use the heater in places where it could be subject to shocks in the immediate vicinity of a
bathtub, shower or swimming pool to avoid drops of water falling on the heater or the heater falling
in the water: If the appliance should accidentally get wet or be submerged in water, remove the
plug from the supply socket immediately and dry the unit carefully. Check that no liquid has gone
inside and if in doubt, contact professionally qualified personnel.
• The heater should be installed 20cm to 100cm from the floor for best performance.
• Kit wall mounted (included inside the box): 1 x Drill Bit (8mm), 4 x Plastic Mounting Lugs, 4 x
Fastening Bolts, 4 x Caps for Bolts.
• If the appliance is fitted to a wall, the same must be made of masonry and/ or of heat-resistant
material (not of wood or synthetic material which rapidly heats up), care should be taken not to fit
panels where water pipes or electrical wiring might be embedded in the walls; follow the
indications below for installation:
- Use the holes provided in the carton/polystyrene packaging for make two holes in wall 54,6cm.
apart, perfectly horizontal; insert plastic mounting lugs, fastening bolts and the caps.
• If fixed in a bathroom shall state that the heater is
to be installed so that switches and other controls cannot be touched by a person in the bath or
shower.
• Warning: don’t use wet hand touch the working machine and don’t cover the wind outlet and inlet.
• Before each use, verify that the heater is in good condition and that the electrical cord is not
damaged: in the case of doubt, ask for professionally qualified help.
• Make sure that the cable is correctly positioned and that it is not in contact with hot parts or sharp
edges, nor wrapped around the device or twisted.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
• Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly. Check that no other high absorption appliances are connected to the same
power source.
• In the case of a breakdown or fault, switch off the appliance and have it checked by a
professionally qualified technician; repairs made by unqualified persons can be dangerous and
render void the warranty.
USE
Each time before use, check that the appliance is in good state, that the electric cord is not damaged:
in case of doubt, do not use it but contact a qualified technician.
When using for the first time
Attention: to operate the panel heater, to eliminate the "new smell" and any residual oils for
processing at least a few hours. During this operation, ventilate the area in order to eliminate the smell
"new" that emanates from the panel.
To use the panel heater, act as follows:
1) Insert the plug into the socket.
2) Switch on the main switch (pos.”I”).
3) At the end of use, completely switch off the appliance using the main switch (pos.”0”) located on
the side.
For long periods of inactivity, remove the plug from the power socket.
8/24
Assembly page 8/24