manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t
change the page numbering. Keep the language
integrity.
8 / 20
Assembly page 8/20
Fax [phone]
• Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly. Check that no other high absorption appliances are connected to the same
power source.
• In the case of a breakdown or fault, switch off the appliance and have it checked by a
professionally qualified technician; repairs made by unqualified persons can be dangerous and
render void the warranty.
DESCRIPTION OF THE APPLIANCE
A. Main (I/0) switch
B. Grille outair
C. Selection button
D. Display
E. Timer button
F. Remote control
USE
Each time before use, check that the appliance is in good state, that the electric cord is not damaged:
in case of doubt, do not use it but contact a qualified technician.
The fan can be used for ventilation alone or for heating; it is provided with a highly efficient ceramic
resistance, which by itself reduces power consumption as the ambient temperature rises.
It is equipped with the following regulation elements, used by pressing the buttons located below the
control panel or the ones on the remote control. The remote control must be aimed in the direction of
the display next to the switches; before using the remote control, insert its batteries (open the rear
hatch and insert 2 “AAA” type batteries respecting the polarity). In detail, the settings are:
• main (I/0) switch. Every time you finish using the fan heater, switch it off with this switch (pos.
“0”).
• keyboard key “ON/OFF” or remote control to start ventilation, to regulate the power to (I) 1000W
and (I I) 2000W
• timer key (“TIMER”of the remote control and of the keyboard) to start the timer, which stops the
appliance at the end of the time: intervals of 30 minutes can be set, up to a maximum of 7h 30’.
The control panel has a series of luminous LEDs, each to indicate the functions selected.
To use the fan heater, act as follows:
1) Insert the plug into the socket.
2) Switch on the main switch (pos.”I”).
3) Select the desired function:
using the keyboard or remote control, press the ““ON/OFF”” key repeatedly; at each press of the key,
the desired function lights up ( /FAN/I/I I), for ventilation (FAN), regulate (I) 1000W power and
the (I I) 2000W power.
5) To switch off the fan heater, run just the fan for around 3 minutes to cool the resistance (in this way
it will have a longer life); press the “ON/OFF” key of the remote control or of the keyboard.
At the end of use, completely switch off the appliance using the main switch (pos.”0”) located on the
side.
For long periods of inactivity, remove the plug from the power socket.