manual


Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t
change the page numbering. Keep the language
integrity.
Fax [phone]
pool (to avoid drops of water falling on the heater or the heater falling in the water), or in places
where it could be subject to shocks.
• The support surface must be stable (exclude shelf) and not sloping (since the heater could tip over).
• Warning: this symbol indicates the anti-tipping switch. If any buttons have been pressed,
the appliance will start to function immediately.
• Make sure that the fan heater is working correctly: if not, turn the heater off and have it checked by
professionally qualified personnel.
• Make sure that the air-intake grid is not obstructed by objects, fabrics or anything else to avoid the
heater overheating or breaking.
• Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly.
• In the case of a breakdown or fault, switch off the appliance and have it checked by a
professionally qualified technician; repairs made by unqualified persons can be dangerous and
render void the warranty.
OPERATION
Each time before use, check that the appliance is in good state, that the electric cord is not damaged:
in case of doubt, do not use it but contact a qualified technician.
The heating fan can be adjusted using the following:
-Selector (3). By turning the relative knob clockwise, you can select these functions: 0= off,
only ventilation, I= hot air (900W) II= very hot air (1800 W).
-Room thermostat (1). It adjusts the appliance’s functions according to the temperature, continuously
until reaching the set temperature, then at intervals to keep it constant. By turning the relative knob
completely anti-clockwise the heating fan remains off (pos.”-“), when turned completely clockwise it
is set on the maximum temperature (pos.”+“), in intermediate positions the surrounding temperature
is lower.
The base has an anti-tipping switch which allows the heating fan to function only when it is
positioned correctly (when it is put in place, you will hear a “click”) but it stops the appliance if it
tips.
To use the heating fan, follow these steps:
1. Insert the plug in the power socket.
2. Turn the thermostat knob clockwise to the temperature required.
3. Switch on the appliance by turning the selector knob to the position of the required function.
4. If you wish the oscillation function, press the oscillation button (2), and oscillation (i.e., 90°
rotation alternatively right and left).
5. The light (4) turns on and turns off when the appliance reaches the requested temperature; if the
thermostat is set at the maximum level, the appliance works continuously.
6. To switch off the appliance, switch off the resistance completely, let only the fan run for about 3
minutes (pos.
) to cool the resistance (this way it will last longer), then switch off the fan by
turning the knob to “0” (off). Then always remove the plug from the power socket.
Never leave the appliance connected to the socket if it is not in use, especially for long periods.
8/24
Assembly page 8/24