Owners manual

E4
-
WM5
-
Y
525
A00
MOUNTING I
N
STRUCTION
created on 06.10.2016 E4-WM5-Y525A00_0 Page 5 of 7 revised on:
8. Next, install the above assembly through the OE bracket on the axle and through the 1
st
Bilstein
steering damper that was partially installed in step 3. *TIP* Use the OE bolt to position the 1
st
steering damper in the OE bracket on the axle. Thread the Flange Locknut (item #9) onto the Hex
Head Cap Screw (item #7) and temporarily hand tighten. Refer to Figure 6 below and Figure 10 on
page 7.
Using the provided Bill of Materials on page 1, gather the following items:
Item # Description Qty
4 Hex Head Cap Screw, M12x1.25, L=80mm 1
5 WASHER, 12mm 2
6 Nylock Nut, M12x1.25 1
9. Slide one of the washers (item #5) onto the Hex Head Cap Screw (item #4). Then compress the 2
nd
Bilstein steering damper and align the eye loop with the clevis hole on the lower mounting bracket.
Install the Hex Head Cap Screw (item #4) through the clevis hole and damper eye loop as shown
below in Figure 7.
Figure
6
Figure 7
Tie Rod (2” diameter)