Owners manual

WM5

525

A00

MOUNTING I

STRUCTION

created on 06.10.2016 E4-WM5-Y525A00_0 Page 4 of 7 revised on:

6. Tighten the 4 socket head cap screws down so the bracket can no longer move. Re-measure to

confirm the position relative to the OE mounting bracket attached to the axle is still 19 11/32”

(491mm) and reposition as necessary. Once this measurement is confirmed, tighten the 4 socket

head cap screws to 15N•m (11 lb•ft) in an “X” pattern. Ensure that the upper and lower brackets

remain aligned with each other while tightening the socket head cap screws by taking note of the

gap in between them (front vs rear). Now tighten the 4 socket head cap screws to 25N•m (18 lb•ft)

in an “X” pattern.

Using the provided Bill of Materials on page 1, gather the following items:

Item # Description Qty

7 Hex Head Cap Screw, M12x1.75, L=110mm 1

8 Spacer, 12.1mm ID, L=6.5mm 1

9 Flange Locknut, M12x1.75 1

7. Slide the Hex Head Cap Screw (item #7) through the mount on the 2

Bilstein steering damper (the

one that hasn’t been installed yet) as shown in Figure 5. Then slide the spacer (item #8) over the

Hex Head Cap Screw (item #7) as shown in Figure 5.

Figure