Owners manual

E4
-
WM5
-
Y
5
34
A00
MOUNTING I
N
STRUCTION
created: 09.13.16 E4-WM5-Y534A00_1 Page 3 of 5 latest revision: 07.18.17
** Ride heights indicated are typical. Actual ride height is influenced by which factory suspension the vehicle is equipped with and
its condition; optional equipment and accessories on your vehicle, and other vehicle modifications such as replacement coil springs,
wheel and tire combinations, etc.
Modifying/lifting the suspension to your vehicle may raise its center of gravity and may make it more susceptible to loss of control
and/or rollover, which may result in death or serious injury. We strongly recommend that you offset the loss of rollover resistance as
much as possible by increasing tire track width, and that you equip the vehicle with a functional roll bar and cage system.
Wear seat belts and shoulder harnesses at all times, and avoid situations where a side rollover may occur.
On all models it is recommended that the driver side circlip is installed one
position higher than the passenger side circlip.
For example, to achieve the highest lift setting of 2.8” on a 4x4 V6 Double Cab, the circlips should be
installed as follows:
Another example: to achieve the stock ride height setting on a Prerunner V6 Extra Cab, the circlips
should be installed as follows:
d
river
side
(circlip location #2)
p
assenger
side
(circlip location #1)
d
river
side
(circlip location #11)
p
assenger
side
(circlip location #10)