Owners manual

E4
-
WM5
-
Y
505
A00
MOUNTING I
N
STRUCTION
created: 10.29.15 E4-WM5-Y505A00_1 Page 2 of 4 latest revision: 08.22.17
IMPORTANT:
PLACE CIRCLIP IN APPROPRIATE GROOVE TO ADJUST RIDE HEIGHT.
Use appropriate tools to move the circlip. Ensure that the circlip is fully seated in the groove after moving it (you should be able to
rotate it manually in the groove). Install the spring seat in the direction shown only. The circlip must fit completely in the groove
inside spring seat (DETAIL A). Improper installation will cause permanent damage to the shock!
circlip location #1
SPRING
SEAT
CIRCLIP
DETAIL A
circlip location #3
circlip location #5
circlip location #7
circlip location #2
circlip location #4
circlip location #6
circlip location #8
circlip location #9
IF INSTALLED WITH 2" LIFT REAR COIL SPRINGS
Circlip Location
(Driver side / Passenger side)
4x4 3.4L V6
Typical Lift
Heights**
4x2 3.4L V6
Typical Lift
Heights**
#9 / #8 2.3" Do not use
#8 / #7 2" Do not use
#7 / #6 1.6" Do not use
#6 / #5 1.3" 2.6"
#5 / #4 1" 2.2"
#4 / #3 0.7" 1.9"
#3 / #2 0.3" 1.5"
#2 / #1 stock 1.1"
IF INSTALLED WITH OE REAR COIL SPRINGS
Circlip Location
(Driver side / Passenger side)
4x4 3.4L V6
Typical Lift
Heights**
4x2 3.4L V6
Typical Lift
Heights**
#9 / #7 2.3" Do not use
#8 / #6 1.9" Do not use
#7 / #5 1.5" Do not use
#6 / #4 1.2" 2.4"
#5 / #3 0.8" 2"
#4 / #2 0.4" 1.6"
#3 / #1 stock 1.1"