Manualshelf

Owners manual

ManualsBrandsBilstein Shocks ManualsAutomotive47-258075 B8 6112 Suspension Leveling Kit Fits 15-18 F-150
12345
E4
E4E4
E4
-
--
-
WM5
WM5WM5
WM5
-
--
-
Y
YY
Y
5
55
5
48
4848
48
A00
A00A00
A00
N
NN
N
ST
STST
ST
RUCTION
RUCTION RUCTION
RUCTION
created: 10.17.2016 E4-WM5-Y548A00_0 Page 4 of 5 latest revision:
** Ride heights indicated are typical. Actual ride height is influenced by which factory suspension the vehicle is equipped with and
its condition; optional equipment and accessories on your vehicle, and other vehicle modifications such as replacement coil springs,
wheel and tire combinations, etc.
Modifying/lifting the suspension to your vehicle may raise its center of gravity and may make it more susceptible to loss of control
and/or rollover, which may result in death or serious injury. We strongly recommend that you offset the loss of rollover resistance as
much as possible by increasing tire track width, and that you equip the vehicle with a functional roll bar and cage system.
Wear seat belts and shoulder harnesses at all times, and avoid situations where a side rollover may occur.
Instructions for assembly of shock absorber module:
1.
Remove OE dust boot from OE upper mount assembly.
2.
Install the supplied spring seat onto the shock body as shown. Ensure that the groove inside the
spring seat fits over the circlip on the shock body [see page 2 (DETAIL A)].
3.
Install the supplied Jounce Bumper onto the rod, leaving it flush with the top of the chrome length
as shown [see page 5 (Figure 3)].
4.
Using an appropriate spring compressor, compress the coil spring and install it on the shock
absorber.
5.
Install the upper mount over the piston rod end and on to the top of the coil spring. Rotate
upper mount so that its studs are in their original position relative to the lower mount bearing
(as noted in step A). Align the upper coil end of the coil spring with the rubber isolator in the
upper mount.
6.
Install supplied washer
7.
Install supplied lock nut and tighten to 45 N·m (34 lb·ft).
8.
Install assembly on to the vehicle and tighten all fasteners to vehicle manufacturer’s
specifications. This completes the installation.
9.
Check wheel alignment. If necessary, adjust to the vehicle manufacturer’s specifications