Owners manual

E4-WM5-Y527A00
MOUNTING INSTRUCTION
created: 4.22.16 E4-WM5-Y527A00_0 Page 3 of 4 latest revision:
** Ride heights indicated are typical. Actual ride height is influenced by which factory suspension the vehicle is equipped with and
its condition; optional equipment and accessories on your vehicle, and other vehicle modifications such as replacement coil springs,
wheel and tire combinations, etc.
Modifying/lifting the suspension to your vehicle may raise its center of gravity and may make it more susceptible to loss of control
and/or rollover, which may result in death or serious injury. We strongly recommend that you offset the loss of rollover resistance as
much as possible by increasing tire track width, and that you equip the vehicle with a functional roll bar and cage system.
Wear seat belts and shoulder harnesses at all times, and avoid situations where a side rollover may occur.
Instructions for assembly of shock absorber module:
1. Install the supplied spring seat onto the shock body as shown. Ensure that the groove inside the spring seat
fits over the circlip on the shock body [see page 2 (DETAIL A)].
2. Install the supplied Jounce Bumper onto the rod as shown.
3. Install the supplied coil spring.
4. Install OE top mount and OE spring isolator.
5. Install supplied lock nut and tighten to 27 Nm (20 lb·ft).