Owners manual

E4-WM5-Y596A00
MOUNTING INSTRUCTION
created: 12.18.17 E4-WM5-Y596A00_1 Page 2 of 3 latest revision:
ORIGINAL EQUIPMENT REMOVAL / BTS INSTALLATION
Note: Installation of this kit and alignment of the vehicle should be performed by a
qualified technician. Use of proper tools and observance of all safety precautions is
required.
1. Immediately inspect all parts and instructions prior to installation of this kit!
CAUTION!
READ THIS BEFORE REMOVING THE COIL SPRING: There will be a high pre-load force on
the coil spring during installation.
2. Support vehicle on a chassis hoist or make sure the vehicle is on level ground and apply the
emergency brake. Block the wheels for extra safety. Do not lift the front wheels off the
ground. Raise vehicle at the frame allowing the wheels to stay in contact with the ground.
3. Remove the brake line bracket from the axle housing near the lower spring perch. See
figure 1, this will allow the brake line to extend without failure.
Figure 1
Brake line
bracket