Owners manual

E4E4

WM5

WM5WM5

WM5

463A00

463A00463A00

463A00

MOUNTING I

MOUNTING IMOUNTING I

MOUNTING I

STRUCTION

STRUCTION STRUCTION

STRUCTION

created: 05.20.14 E4-WM5-Y463A00_0 Page 1 of 3 latest revision:

IMPORTANT:

PLACE CIRCLIP IN APPROPRIATE GROOVE TO ADJUST RIDE HEIGHT.

Use appropriate tools to move the circlip. Ensure that the circlip is fully seated in the groove after moving it (you should be able to

rotate it manually in the groove). Install the spring seat in the direction shown only. The circlip must fit completely in the groove

inside spring seat (A). Improper installation will cause permanent damage to the shock!

Snap ring location #1

Snap ring location #2

Snap ring location #3

Snap ring location #4

SPRING

SEAT

CIRCLIP

Snap ring location #5

ROD

ADAPTER

PAGE 1
E4E4-WM5WM5-Y463A00 MOUNTING IN INSTRUCTION IMPORTANT: PLACE CIRCLIP IN APPROPRIATE GROOVE TO ADJUST RIDE HEIGHT. Use appropriate tools to move the circlip. Ensure that the circlip is fully seated in the groove after moving it (you should be able to rotate it manually in the groove). Install the spring seat in the direction shown only. The circlip must fit completely in the groove inside spring seat (A).
PAGE 2
E4E4-WM5WM5-Y463A00 MOUNTING IN INSTRUCTION IMPORTANT! Installation of shock absorbers requires special tools and expert knowledge. Accordingly, installation of all BILSTEIN products must be performed by a qualified suspension specialist. Always use a chassis hoist for the installation of BILSTEIN products and make certain that the raised vehicle is securely attached to the hoist and/or supported to prevent the vehicle from slipping, falling, or moving during the installation process.
PAGE 3
E4E4-WM5WM5-Y463A00 MOUNTING IN INSTRUCTION BILSTEIN LOCK NUT OE MOUNT COMPONENTS BILSTEIN COIL SPRING BILSTEIN ROD ADAPTER BILSTEIN SPRING SEAT created: 05.20.