Owners manual

■ Fix the brake pipe bracket. Ensure that there is
enough space between pipe and chassis.
■ Assemble the level control sensor 햻.
■ Mount the wheel.
■ Tighten the 4 nuts on the strut dome
(torque to 30 Nm) 햽.
■ Screw on pressure line (torque to 5 Nm) 햾.
Check O-ring – replace if necessary.
■ Insert electric plug of the strut being fitted 햿.
Pay attention to the correct position of the
plug slot.
■ Lower vehicle until wheels encounter the
floor slightly.
Never under any circumstances allow the vehicle
to be fully lowered from the lifting hoist with the
air suspension depressurized.
■ Start the engine and release the parking brake.
Prevent vehicle against accidentally rolling.
■ Lower the vehicle until approx. 380 mm (lower
edge of the fender – axle centre) from the car
hoist and wait at least for 2 minutes.
■ Lower the vehicle until approx. 340 mm – only
lower completely when the vehicle raises of its
own accord.
■ Check air suspension system for leaks.
■ Fully tighten screws loosed during the work in
ready-to-drive-condition in accordance with the
car-manufacturer’s specifications.
■ A following front end alignment is required.
Note:
Manufacturer shall not be liable for any injury, loss or damage resulting
from any improper alteration, disassembly, handling, installation, service,
repair or use of this product, including but not limited to the failure to follow
the foregoing instructions.
Improper alteration, disassembly, handling, installation, service, repair or use
of this product will void the product warranty.
E4-WM5-Y385A00
!
!
!
!
햻
햽
햾
햿