Owners manual

39
CHANGING
THE HOSE.
STEP 1
Remove piston rod assembly from shock body.
(Refer to the section: Piston Rod Assembly Removal,
page 12)
STEP 2
Drain shock oil.
(Refer to the section: Draining the Oil, page 20)
STEP 5
Replace new hose on reservoir.
STEP 6
Fill shock with oil.
(Refer to the section: Filling the Oil, page 29)
STEP 7
Install piston rod into shock body
(Refer to the section: Installing the Piston Rod, page 30)
STEP 8
Charge shock with desired nitrogen pressure.
(Refer to the section: Pressurizing the Shock
Absorber, page 32)
STEP 3
Remove reservoir hose from shock body using 7/8” box
wrench.
STEP 4
Remove hose from reservoir end cap using (2) 7/8” box
wrenches.
WARNING!
Release gas pressure and complete section Piston Rod Assembly - Removal, page 12-13, before continuing.
!