Owners manual

FILLING

THE OIL.

STEP 1

Placing shock body upside down in vise, attach

reservoir hose and tighten using a 7/8” box wrench.

STEP 2

Fill oil into open end of the shock body. Use the

proper oil volume by referencing the chart on page 41.

STEP 3

Loosen vise and lean shock at an approximate 10 degree angle and retighten vise. Allow several minutes for the air

bubbles to surface and dissipate. When the air has purged from the oil, there should be an approximate 45-60mm gap

between the oil and the end of the shock body. Once the oil has stabilized, move onto the next section (Installing the

Piston Rod).

Use a buering layer between the clamp and

eyelet, such as a towel, to avoid scratching the

anodized end cap.