Owners manual

25
RESERVOIR RESEAL -
ASSEMBLY.
STEP 1
46mm & 60mm - Install new o-ring on Schrader
TM
end cap. Use white lithium grease on o-ring to aid in
installation.
STEP 2
46mm & 60mm - Install new o-ring, on reservoir end cap.
Use white lithium grease on o-ring to aid in installation.
Continue on to step 3 (60mm) or step 5 (46mm).
Piston & Dividing Piston Wearband (x2): Piston Wearband:
Before starting, you must determine if you have a 60mm or 46mm shock (refer to section: How to Measure
Your Shock Absorber, page 4) and purchase the necessary components. All seals and components are includ-
ed in the seal kits shown on page 11, or can be purchased separately using part numbers below.
60mm Seals:
Reservoir End Cap O-Ring (x4): Reservoir End Cap O-Ring (x4):
Dividing Piston (Complete):
Dividing Piston O-Ring:
46mm Seals: